SNK
Member
Hi all.
Has anyone used RSNETWORX for DEVICENET recently?
I am attempting to upload the device EDS and information about my devicenet network and I cannot seem to get online with the devicenent scanner located in a SCL 5/05 rack.
I am using RSLINX to communicate through a ethernet switch, and can establish comms with the SLC and the PV on the network at two different node addresses (IP's). As far as I remember, I should be able to see the scanner if I expand or drill down into the SLC chassis from Rslinx.
The problem is....I can't.
In RSNETWORX for Devicenet, if you go online, it basically brings up the Rslinx window of the path that has already been established...I guess using Rslinx as a porthole to the scanner. Well, because I cannot see the scanner, I cannot accept the communication changes to upload from the scanner....so I cannot see or change my network.
Are there any suggestions???
BTW, I am using win2K, 5.21 Rslogix500, and I cannot remember the version of Rsnetworx.
Has anyone used RSNETWORX for DEVICENET recently?
I am attempting to upload the device EDS and information about my devicenet network and I cannot seem to get online with the devicenent scanner located in a SCL 5/05 rack.
I am using RSLINX to communicate through a ethernet switch, and can establish comms with the SLC and the PV on the network at two different node addresses (IP's). As far as I remember, I should be able to see the scanner if I expand or drill down into the SLC chassis from Rslinx.
The problem is....I can't.
In RSNETWORX for Devicenet, if you go online, it basically brings up the Rslinx window of the path that has already been established...I guess using Rslinx as a porthole to the scanner. Well, because I cannot see the scanner, I cannot accept the communication changes to upload from the scanner....so I cannot see or change my network.
Are there any suggestions???
BTW, I am using win2K, 5.21 Rslogix500, and I cannot remember the version of Rsnetworx.