arkansascontrols
Lifetime Supporting Member
I'm writing a new program for a project offsite, no PLC or VFD's at development time.
I add the PowerFlex 525 to my v20 project and it defaults to a single Phase 110v .5hp drive. I have several drives to add to the project and I'd like to configure the drives in Logix correctly. The Properties Dialog is disabled (greyed out) so I can't change the basic Drive info (voltage/hp etc). I know I can go back and change once I'm online but surely there's a way to at least enter the basic drive details offline.
Any suggestions would be appreciated.
I add the PowerFlex 525 to my v20 project and it defaults to a single Phase 110v .5hp drive. I have several drives to add to the project and I'd like to configure the drives in Logix correctly. The Properties Dialog is disabled (greyed out) so I can't change the basic Drive info (voltage/hp etc). I know I can go back and change once I'm online but surely there's a way to at least enter the basic drive details offline.
Any suggestions would be appreciated.