Kinetix 6000 - Fault E70 / Non-volatile memory is corrupt.

Good Morning ,

I had a dead battery on a 1756 CPU. Replaced the battery and reloaded the program . Have a Kinetix 6000 that has a E70 fault- Non- Volatile memory is corrupt due to control board software error. Does these Kinetix drives have batteries ? What could cause this ?

Thanks in advance .

http://cedtechconsultants.com/wp-content/uploads/2016/06/Kinetix-6000-Troubleshooting_rev1.pdf

The above troubleshooting guide should help you out.

E70 - Non-volatile memory is corrupt due to control board software error. DriveHardFault Load default parameters, save to non-volatile memory, and recycle power or (NV Mem Init) reset the drive.

Regards,