new to PLC subject, and dont know where to start

yeksm

Guest
Y
hi there,,

Anyone can give me advise where to start PlC programming, or may be start from whic brand and software,, actually I learned PLC in my school long aga, that time we using OMRON, but i almost forget it,,
Hope anyopne can help me show the perfect for starting PLC carrer..

Thanks

TOMMY
 

Similar Topics

R
Post subject: Mitsubishi PLC RS485 2W Communication to Weintek HMI..
We have two PLCs both are Mitsubishi-FX2N, and we want them to communicate to Weintek HMI MT8100ie. MT8100ie can communicate with Multiple PLC and...
Replies
1
Views
4,965
Seipy
S
P
AB PLC, Rslogix 5000, alarm issue
Hi folks, in the alarm manager of Rslogix 5000, the tag-based alarm has been created. But when I tried to change the condition, it was found the...
Replies
0
Views
18
PLCbug123
P
H
PLC NAT Suggestions.
I know this topic has been brought up a few times, but i had some specific questions. I have installed several 1783-NATR devices and they have...
Replies
0
Views
37
HoldenC
H
H
No communication with PLC 90-70
Hello We have installed several G.E. Fanuc 90 70 PLC Everything was ok but suddenly we can not communicate anymore with any PLC with the software...
Replies
0
Views
33
Hazatov
H
Voltimus
IDEC PLC to PLC modbus communication
Apologies for not being the best IDEC programmer. I recently was doing some inspections on a site that had 3 FC6A IDEC processors. The issue is...
Replies
0
Views
51
Voltimus
Voltimus
Back
Top Bottom