MinnesotaMulisha
Member
Hello everyone. I'm fairly new to PLCs. I took some programming classes in college back in 2000 and haven't done a whole lot with anything other than RS5000 since then.
I recently bought a Micrologix 1000, 1761-L32BWA off of ebay, which may or may not have been a mistake. I am trying to connect to it now. I am using the free version of RSLogix Micro Starter Lite, Version 8.30.00.
I have RSLinx Version 2.57.00.14 CPR 9 SR 3.
I bought a cable (USB 1761-CBL-PM02) which is USB to RS232.
I am having problems connecting.
I created a driver in RSLinx, which is RS232 DF1 Devices.
When I go to RSWho, I can see the processor. If I expand the tree, I can see teh processor, labeled: 00, Workstation, DF1-COM4.
When I try to go online, I get a popup window that says: "No Response from Processor at selected path/node"
If I try to upload, I get the same thing.
Any ideas why I can't communicate with this thing?
Thanks in advance!
I recently bought a Micrologix 1000, 1761-L32BWA off of ebay, which may or may not have been a mistake. I am trying to connect to it now. I am using the free version of RSLogix Micro Starter Lite, Version 8.30.00.
I have RSLinx Version 2.57.00.14 CPR 9 SR 3.
I bought a cable (USB 1761-CBL-PM02) which is USB to RS232.
I am having problems connecting.
I created a driver in RSLinx, which is RS232 DF1 Devices.
When I go to RSWho, I can see the processor. If I expand the tree, I can see teh processor, labeled: 00, Workstation, DF1-COM4.
When I try to go online, I get a popup window that says: "No Response from Processor at selected path/node"
If I try to upload, I get the same thing.
Any ideas why I can't communicate with this thing?
Thanks in advance!