ABB IRC 5 Status bits to ControlLogix

Scottwalth67

Member
S
Join Date
Apr 2017
Location
Chattanooga TN
Posts
1
Hello all, I am fairly new to ABB Robotics (FlexPicker) and have been asked to see if there is a way to get status bits to a ControlLogix PLC. Reading some articles I see a Ethernet card can be placed in the ABB IRC 5 panel and ran to the PLC to an Ethernet card there. The PLC is not a problem, well, setting up the actual comms may be challenging but that why we all playing with this stuff! Anyway, the information being reqested from the ABB is idle time, faults, run time, etc. Has anyone played with this or know if this is doable? Any info would be appreciated. o_O
 

Similar Topics

EICS
ABB PS501 Control Builder Plus V2.3 Install - anyone use it or know of it
does anyone have an install or know if/where i can download it for the following "ABB PS501 Control Builder Plus V2.3 " the software was a free...
Replies
2
Views
61
ojz0r
O
S
IE5 ABB motor and VFD
Hello, It is mandatory to use VFD IF i use IE5 electrical motor? What happens If connect it directly as delta without VFD? Please look at motor...
Replies
1
Views
119
kamenges
K
R
ABB ACS800-07 VSD fault on ramp up between 98 and 100%
Hi hoping someone can assist me with current issue I am experiencing with an ABB drive. Problem I’m experiencing is a ABB drive supply a large...
Replies
4
Views
193
BryanG
B
R
ABB AC500 (PM573-Eth) PLC Program Backup
Hello all, I have an ABB PLC (PM573) and it has without MC card. I need to take backup from PLC to PC (in automation builder v2.7 ). My...
Replies
10
Views
408
arpus4KM
A
O
Remote Connection to ABB MOD300 OPC Server - Difficult or Impossible
Folks, I have a client with an old ABB Advant / MOD300 system (v14.4). Around y2k I installed the ABB Industrial IT MOD300 OPC Server 1.1/2...
Replies
1
Views
164
odwyerpw
O
Back
Top Bottom