Connect 2 controllers with EtherNet/IP through a router

You could also check into a NAT device like the A-B 1784-NATR. Use one -NATR per each "private-network" Compactlogix and network the public side of each -NATR to an IP address on the same network as your Omron PLC
 
BinderNut said:
You could also check into a NAT device like the A-B 1784-NATR. Use one -NATR per each "private-network" Compactlogix and network the public side of each -NATR to an IP address on the same network as your Omron PLC
Click to expand...




^this.


When I mentioned Stratix earlier, I meant -NATR.
 

Similar Topics

C
MSG instruction connect failure between ControlLogix5572 and MicroLogix 1400.
I'm using a SLC typed write from the ControlLogix5572 to the MicroLogix 1400, with path: 2, (MicroLogix IP). The ControlLogix equipment has a...
Replies
0
Views
87
Chris3EC
C
P
How to connect to Schneider M241 PLC remotely from EcoStruxure Machine Expert software using SSH tunnelling?
Hello, As part of our project, we are using an M241 controller. This controller interfaces with an industrial computer and a router via a switch...
Replies
2
Views
103
Para
P
T
HMI shows motor running even though disconnect is on.
Here's what happened, Operator turned on the disconnect for an auger while it was still running to cut power. Auger DID in fact turn off, but the...
Replies
8
Views
335
TheColt46
T
J
Rockwell Techconnect service contract price increase?
What has been your experience with year over year price increases on your Tech-connect service contracts? Is it up to the distributor? 30% seems...
Replies
5
Views
287
bill4807
B
A
Connect a single quadrature encoder to more than one input device
Hello, friends, I am trying to upgrade a system that uses an Onrom incremental encoder (E6B2-CWZ6C) connected to a Danfoss VFD (FC360), but now...
Replies
4
Views
271
Aure_PLCs
A
Back
Top Bottom