OT: Oddball Pipe Union

deanfran

Member
D
Join Date
Apr 2011
Location
NY
Posts
84
This machine we are dealing with has a bunch of these, and we haven't been able to ID them. The thread is straight metric 1.5M, but that's about all we can determine. A rubber o-ring fits inside the cup of the male thread end. We've contacted the machine OEM, but haven't heard back. Anybody ever seen this?

Fitting.jpg
 
Good thought. I wish it was bevel seat. I can get those all day. Personally I've never seen a standard bevel seat that small.
 

Similar Topics

C
EBM Papst D3G146-HQ13-34 Blower Motors - Seems like a Real Oddball
Good Evening , I have an " Oddball " Blower Motor , and really do not have any U.S. support . It is a manufacture called EBM Papst and the...
Replies
4
Views
1,138
Rounder
R
U
C.N.C. oddball
Hi, I am trying to find out any sort of information possible on an old C.N.C. machine that was built by Northern Control Systems Inc from Addison...
Replies
0
Views
1,816
Unregistered
U
C
Pipe Animations, Yes or No??
Hello, I've searched long and hard for this and found a great thread from 2008 about animating pipes and it turned out it was a bit of a flame...
Replies
7
Views
147
parky
P
A
OT: Small Pipe Temperature Sensor
Hi all, Related to my other post, I also need to measure some quite low temperatures (down to -50°C) in pipes. For the most part this is fine -...
Replies
4
Views
1,562
ASF
A
K
What's this pipe the motor wire is running through?
Good morning, Curious what the function is of this piece of steel pipe that a motor wire run through. The same thing is installed in the encoder...
Replies
2
Views
2,694
kalabdel
K
Back
Top Bottom