Omron I/O units
- Thread starter yahmsn
- Start date
gtsuport
Member
yahmsn,
Welcome to the forum.
Both of those modules will use two consecutive I/O channels.
If you look at the I/O Table in the Project workspace on the left side of the CX-Programmer screen, it will show you the starting I/O channel for the module.
I hope this will help.
Welcome to the forum.
Both of those modules will use two consecutive I/O channels.
If you look at the I/O Table in the Project workspace on the left side of the CX-Programmer screen, it will show you the starting I/O channel for the module.
I hope this will help.
thank you
Similar Topics
Hi There,
I have couple of Omron PLCs connected on my kepserverex and my intouch reads data from kepserverex. I have been observing that roughly...
Hi dear . I have a system with cj1m cpu11 etn. previously NT 5z HMI was connected with plc. recently my old HMI got damaged. I want to replace it...
Omron AD081-V1 Analog Input Card
Offset & Gain Adjustment
Entering Adjustment Mode
1. Set the input card in adjustment mode (Turn ON Dip SW No-1)...
I am working on a project using a NB screen and NX1P2 PLC.
I am having a really hard time getting a real number to properly translate through to...
Hi, I am facing an error inside Omron Network Configurator.
I have 2 PLC communicate each other using ethernet cable, send signal using Network...