CU 305 Dp position control with S7-200

falgunvasava

Member
F
Join Date
Jan 2009
Location
gujarat
Posts
60
Is it possible to control position of servo with CU305 dp by giving pulse output from S7-200?
I just want to run the motor a fix speed( if i can vary speed through pulses,its fine) and control the exact number of rotations using S7-200.
Anyone have any idea.
 

Similar Topics

M
Emerson PAC/RX3i CPE305 Controller - Troubleshooting/Viewing Eth. Ref. Address
Hello all, First time poster, long time viewer of these forums. Could not find my solution on here. We have had issues with a Comm Fail on an...
Replies
2
Views
377
MichaelIEC
M
D
1305 Reverse over RIO
I am looking at a 1305 drive connected to a PLC5 via RIO. The drive is working and I was able to get a functional HIM working on the drive as...
Replies
3
Views
1,850
daviper1996
D
W
Upgrading from 1305 on SCANport
Hi Everyone, We do have several cabinets with SLC5/03 CPU's and two SCANport modules, each. 5 ports are being used, communicating with 1305 VFDs...
Replies
4
Views
2,469
woodfritz
W
A
TISOFT Compatibility between Texas 505 & 305 CPUs
Hi, Just looking for a quick pointer. I want to upload an old program out of a Texas 305 PLC. The program was last downloaded in the 90s so...
Replies
10
Views
2,030
andy_1983
A
D
Ge 305
i have 10 signals for 10 different tanks in service.how can i find out how many are online or offline at any time..... Thanks
Replies
4
Views
1,334
drbitboy
drbitboy
Back
Top Bottom