GE FANUC PLC 4 sale

ronboom

Member
R
Join Date
Jul 2004
Location
Spring Lake, MI
Posts
22
Listing is attached. Will send photos if interested. Looking to get the cost of the software back -- $125 plus shipping for everything. I think the processor is bad. New Power Supply & a couple new I/O Modules. Got sick of trying to figure out what was wrong with it so I replaced it with a SLC 5/03. I've never programmed these before and this stuff is just setting in a box on a shelf.
 

Similar Topics

S
What options for uploading from an old GE Fanuc Series One PLC?
Got an old machine with a IC610CPU104 CPU. A bit of research told me this is the same as DL305 so DirectSoft from AutomationDirect should work...
2
Replies
15
Views
2,004
strantor
S
A
PLC GE-Fanuc can Online Edit Program while CPU Run Time ?
Dear Everyone I work with PLC GE-Fanuc. But I don't know that "PLC GE-Fanuc (Series 90-30 and VersaMax) can Online Edit Programming while...
Replies
9
Views
3,019
alpine
A
U
GE Fanuc PLC programming
Our PLC output 7 opens a valve to move a cylinder rod. The output turns on every minute. The output is supposed to be ON for 10.56 seconds. But...
Replies
3
Views
2,852
Steve Bailey
Steve Bailey
W
GE Fanuc 90-30 PLC Software
Need to find where to get VersaPro or Proficy software for the GE Fanuc 90-30 PLC.
Replies
5
Views
2,521
geniusintraining
geniusintraining
A
How does wrt.not work in fanuc plc programming?
Good afternoon all, hope everyone is doing well. Could someone explain the pic attached on the wrt.not instruction? To me, it looks the same as...
Replies
6
Views
2,101
NetNathan
N
Back
Top Bottom