Square D Motor Logic Plus II

I am trying to understand how Motor logic PLUS II works.
My questions is I am trying to send run command from PLC through Devicenet network. I mapped address in the Devicenet module in PLC.

But i am not understanding at motor Logic Plus II, which bit actually will be run command at motor logic plusII. Also since i am sending word through devicenet network whether it requires byte swap or not.


I read the Square D Motor logic plus manual and programming manual but i am not clear it.
If anybody please show me or little explain me it will be great help.

Also please tell me how to understand it from motor logic plus II eds file.