Look for Cognex SensorView OS

Join Date
Jul 2017
Location
Michigan
Posts
21
Long shot here but I'm up against a wall with this. The CF card got corrupted on a Cognex SensorView 2, the 890 model, and there is not a backup.

Cognex told me they don't support it anymore, nor could I download the ISO file I would need from them.

I'm hoping someone has a SensorView and can rip me an ISO from the CF card and send it to me?

Thanks in advance!
 
Can I bump this? Not sure the rules about bumping.
I called the panel PC mfg and they said they don't support cognex's custom build. I asked if they have a vanilla boot file I can use but no word back.

No one uses Cognex anymore? I personally like their vision sensors.
 
The only support they have for the SensorView 890 is firmware updates.
I called Cognex and asked if I could purchase a replacement CF card and they said that was not possible, as they do not support the 890 anymore. Nevermind that I have 7 or 8 of their vision systems in use, they want me to upgrade to VisionView which is overkill for a vision sensor.
 

Similar Topics

We finally replaced our Cognex Checker with an IV-3 and I'm wondering if can replace the s/w in the monitor with anything else. I haven't been...
Replies
0
Views
77
Thank you for any and all responses/help. I have an RSLogix 5000 v20 and a Cognex In-Sight v5.9 spreadsheet (8502P). I can not figure out how to...
Replies
0
Views
101
Which signals do I have to use to get data from camera. For example camera detects a defect and sends signal to controller. Power cable: CCB-PWRIO-05
Replies
1
Views
160
Good People of PLCTALK. I am trying to understand the pass-fail on one of our product lines. I was able to record the Cognex images on the...
Replies
2
Views
222
Gents, We have the following configuration: A Beckhoff PLC with EthercatMaster > EK1100 with a EL6652 EthernetIP Master. Plan is to...
Replies
2
Views
361
Back
Top Bottom