gollywomp
Member
Hello,
I am new to PLC & HMI programing as well as PLCS.net (an awesome resource so far!)I know I am going to leave out useful information so please be patient with me.
Were using Modbus protocol.
I have an up counter with a set limit of 500 (C100 K500)
I want to be able to adjust the limit from the G306k.
I have set a integer variable mapped back to C100. I'm unsure if i need to scale or transform the integer. From my understanding when you create an integer flag it should pop up a numeric key pad. At this time it does nothing.
Any help would be greatly appreciated.
I am new to PLC & HMI programing as well as PLCS.net (an awesome resource so far!)I know I am going to leave out useful information so please be patient with me.
Were using Modbus protocol.
I have an up counter with a set limit of 500 (C100 K500)
I want to be able to adjust the limit from the G306k.
I have set a integer variable mapped back to C100. I'm unsure if i need to scale or transform the integer. From my understanding when you create an integer flag it should pop up a numeric key pad. At this time it does nothing.
Any help would be greatly appreciated.