saineshkumar190
Member
Hello friends,
I'm facing an issue while communicating cimplicity HMI 5.0 with GE PLC Series 90-30. Scada backup provided to me is using protocol series 90 Ethernet, the problem is when i start the project and check the device (quickview) i'm getting device down.
I've also tried by creating a new project with s90 triplex to communicate but no success.
While communicating from versapro 2.0 for logic it's communicating with PLC, so can't say Port is faulty.
Thanks in advance.
I'm facing an issue while communicating cimplicity HMI 5.0 with GE PLC Series 90-30. Scada backup provided to me is using protocol series 90 Ethernet, the problem is when i start the project and check the device (quickview) i'm getting device down.
I've also tried by creating a new project with s90 triplex to communicate but no success.
While communicating from versapro 2.0 for logic it's communicating with PLC, so can't say Port is faulty.
Thanks in advance.