Phil_Meckem
Member
Has anyone experienced the Relay on a Powerflex 4M going bad and not switching when the drive faults. Perm T221 is set to 0 and it will change if the drive loses power but will not switch if the drive faults. Please Advise.
Power Flex 4m Relays
- Thread starter Phil_Meckem
- Start date
Similar Topics
Power flex 527 Network based safety drive had faulty and alarm pop up SOS Code internal fault
Unable to set or clear the fault manually or...
Hi all.
Would anyone happen to have the Modbus register datasheet for the Honeywell/EnergyICT EIMFlex Modular Meter v1.11
We've 40 of these that...
I have an issue with Power Flex 525 during running processing, the VFD stopped suddenly while the PLC and VFD connection ok, VFD does not have any...
I am trying motor startup with pf525 drive by using wizard start over ethernet communication but during direction test it's showing control error...
i have a flashing yellow sts light. "Stop Asserted" message on one of my PF 753"s, but no bits set in parameter 961. The safety circuit tests...