Slc 500 address

Bling_bling

Lifetime Supporting Member
B
Join Date
Nov 2016
Location
Ohio
Posts
23
So yesterday I used a laptop which had the addresses set to address to the sum bit in the data table instead of the word bit. Example O:1/48 instead of O:3/15 (I hope I'm explaining this correctly)
How is this changed?
 
You can set the display to show binary data type in that way. By setting it up under "view properties" "address display". See picture.

I didn't know that could be done for "output" data type.

Can you post the program, zip it first.

What software are you using?

viewproperties.png
 
Last edited:

Similar Topics

AutomationTechBrian
Modifying a SLC 500 file to change an output address.
A customer asked if I could change an output address in a SLC 500 that he thinks is bad. I've not worked with that PLC before, so I asked him to...
Replies
6
Views
2,597
I_Automation
I_Automation
U
slc 500 ip address retrieval
hello everyone, i am using a panelview 600 communicating with an slc 5/05 thro rs 232 port. I have misplaced the ip address of the processor...
Replies
3
Views
4,185
Mickey
Mickey
O
Setting IP Address on Ethernet Module Slc 500
How do you assign an IP address to Ethernet module for SLC500 ?
Replies
14
Views
14,522
geniusintraining
geniusintraining
M
SLC-500 SQO info wont go through mask
I have a program that I've used 100 times. SQO settings: File N7:0, Mask 0FFFFh, Dest B3:1, Control R6:0, Length 8, Pos 2. Length & Position...
2 3 4
Replies
48
Views
938
drbitboy
drbitboy
J
Slc 500 software & Siemens plc question
Everyone, i am in the process of purchasing the Slc 500 version of software to support what we have and i have a question. Several of our...
Replies
9
Views
751
James Mcquade
J
Back
Top Bottom