JiNCs
Member
Hey folks.
I have a system I'm starting that will be much like a similar existing system. I will take the old program and make changes to it for the new system.
In trying to duplicate the existing 315-2 CPU system, some modules have been outdated/updated/changed. One of the these is a two module remote rack that used a 153-1 inteface module. In the new system it has been replaced with an IM 365 send/recieve module.
The CPU rack has a power supply and modules 4 through 11. I think its full except for slot 3.
I can delete the 153 from the system at the rail view. How do I add the 365 to the system? The send module is physically added to the end of the CPU rack after slot 11 and the recieve is physically added at the start of the remote rack. Is that allowed? I ask because I can only get the module to add in slot3 of the CPU rack. I cannot get it to hang off the rail on the hardware config view where the 153-1 was.
Need a little help here!!!!
Thanks
JiNCs
I have a system I'm starting that will be much like a similar existing system. I will take the old program and make changes to it for the new system.
In trying to duplicate the existing 315-2 CPU system, some modules have been outdated/updated/changed. One of the these is a two module remote rack that used a 153-1 inteface module. In the new system it has been replaced with an IM 365 send/recieve module.
The CPU rack has a power supply and modules 4 through 11. I think its full except for slot 3.
I can delete the 153 from the system at the rail view. How do I add the 365 to the system? The send module is physically added to the end of the CPU rack after slot 11 and the recieve is physically added at the start of the remote rack. Is that allowed? I ask because I can only get the module to add in slot3 of the CPU rack. I cannot get it to hang off the rail on the hardware config view where the 153-1 was.
Need a little help here!!!!
Thanks
JiNCs