Hi folks,
I am struggling quite lot with NAT in Scalance switch XC208.
Main task is to isolate lan and production network. I would like to have Main PLC in two VLAN's - VLAN 1, VLAN 2. However in VLAN2 I would like to use NAT function and mask IP adress from 192.168.0.21 to 10.10.10.60. I have been through documentation and followed steps (VLAN assigment, port definition, NAT function of VLAN interface, Pool). But it does not work. In VLAN2 I can ping switch itself (192.168.0.1 - 10.10.10.1 ) but not PLC.
Has someone faced same problem as me in the past and solved NAT functionality on Scalance switches ? Compared to other products, it is really user unfriendly and disaster in parametrisation .
Any response appreciated.
Thanks in advance.
I am struggling quite lot with NAT in Scalance switch XC208.
Main task is to isolate lan and production network. I would like to have Main PLC in two VLAN's - VLAN 1, VLAN 2. However in VLAN2 I would like to use NAT function and mask IP adress from 192.168.0.21 to 10.10.10.60. I have been through documentation and followed steps (VLAN assigment, port definition, NAT function of VLAN interface, Pool). But it does not work. In VLAN2 I can ping switch itself (192.168.0.1 - 10.10.10.1 ) but not PLC.
Has someone faced same problem as me in the past and solved NAT functionality on Scalance switches ? Compared to other products, it is really user unfriendly and disaster in parametrisation .
Any response appreciated.
Thanks in advance.