Would anyone have the comm. cable pinout handy to connect to a laptop 9 pin serial port(rs232). The manual tells me I need an rs422 to rs232 converter, but at one time we had a cable for this plc and I'm positive there was not a converter on it.Thanks in advance.
GE Fanuc series 90 Micro
- Thread starter ctilley
- Start date
sthompson
Lifetime Supporting Member + Moderator
Have a look at Appendix A of this manual.
http://support.gefanuc.com/support/...tent/live/DOCUMENT/0/DO696/en_US/gfk0356q.pdf
Also do a google search, there is all kinds of information out there.
Hope that helps.
Stu......
http://support.gefanuc.com/support/...tent/live/DOCUMENT/0/DO696/en_US/gfk0356q.pdf
Also do a google search, there is all kinds of information out there.
Hope that helps.
Stu......
Steve Bailey
Lifetime Supporting Member + Moderator
Similar Topics
I hope there is someone out there that can help. I recently inherited 35 Magnum presses (circa 1995) that have GE Fanuc Series 90 micro PLC's...
Have anyone softwer for this device for download free ???
We are converting an old GE to a S7 as a rush project.
Don't you love the 4:30 on Friday phone calls.
I need to know how a specific memory space...
I have a GE Fanuc Series 90 Micro that I am trying to upload the ladder logic from. I can connect to it, change the RUN/STOP state, and read the...
Hello,
I have a series 90 micro PLC, IC693UDR001NP1.
year ago i have upgraded firmware to 3.10 and then it worked with VersaPro 2.02 with no...