Explicit Message To PF523 (25-Comm-D) to 1746-SDN

patsul

Member
Join Date
Mar 2015
Location
Cork
Posts
1
I currently have a SLC 5/04 with a 1746-SDN DN interface module, there is a PF523 on the devicenet network that I want to read multiple parameters from. I am connected to PF523 via 25-Comm-D.
I have configured an explicit message to read a single parameter and this works correctly however when i try to setup a message to read multiple parameters it fails. Any ideas/help would be appreciated?

My working message for a single parameter read is as follows..
0101, 0006, 0E09, 0093, 14(Dec), 0009
 

Similar Topics

We are going to pull 5-10 INT parameters out of 6 soft starts via explicit messaging in logix 5000. It's the only way we can read these over...
Replies
7
Views
2,416
Hi, Did anyone succeed to send an explicit message to a Devicenet node? The official UDFB RA_DNET_EXPLICIT is not compiling. According to...
Replies
1
Views
1,410
Does anyone know how much time a L71 controller takes to response an EtherNet/IP explicit message? From my understanding, the time for a...
Replies
0
Views
1,155
I have been using explicit MSGs to write parameters to PFlex Drive and 20-COMM-D to setup comms for DNet. These will setup Speed Ref, datalinks...
Replies
0
Views
1,612
Hi all I have som problems communicating with a 9300 servodrive from Lenze over the devicenet via explicit message. Im using RSNetworks "Class...
Replies
0
Views
2,074
Back
Top Bottom