Wade Greene
Member
Does anyone have a manual or know where I can get a manual for a Allen-Bradley IMC-121. It goes in a PLC5. Also do you know which software i need to look that program?
Imc 121
- Thread starter Wade Greene
- Start date
sigmadelta
Member
Wade Greene
Member
OP
That was the first place I looked. The only thing is a Russian version. There are plenty of IMC-120 manuals, but no IMC-121
This seems to be all they have:
http://search.rockwellautomation.co...*&lang=en&hl=en&sitelang=en&dnavs=+1771-6.4.3
Look at page P-4 in this document, and look for the publication numbers:
http://literature.rockwellautomation.com/idc/groups/literature/documents/um/mcd-um001_-en-p.pdf
http://search.rockwellautomation.co...*&lang=en&hl=en&sitelang=en&dnavs=+1771-6.4.3
Look at page P-4 in this document, and look for the publication numbers:
http://literature.rockwellautomation.com/idc/groups/literature/documents/um/mcd-um001_-en-p.pdf
Wade Greene
Member
OP
Thanks, I went down that road and didnt find anything. The only thing I can guess is the 120 is similar.
Similar Topics
Hi Forum,
I am experiencing a problem with an Allen-Bradley IMC-121 module. The module is 'deselecting' the program file during normal...
Hello, I am currently having an issue with an Allen Bradley IMC 121 Axis Controller Card (I know Ancient!). It is being used with an Allen Bradley...
Hello friends,
I'm asking a new question here, after thinking a lot about my problem, I wondered if it wouldn't be easier for me to install new...
Hello all,I'm trying to use IMC function to control a very slow system.
I have set the parameters, but I haven't started autoturn yet. The...
So I am controlling a process with a very large dead-time. Because of this I found that the AB IMC function block worked the best to control the...