S7-400H PLC & IND331 Mettler Toledo Communication

sachin.patil

Member
S
Join Date
Jun 2015
Location
Pune
Posts
4
Hi All,
We are using Metteler Toledo IND331 device to measure weight. We are trying to establish the Profibus communication between S7-414 H CPU and IND331.
We configured Profibus address in IND 331 and also same address configured in PLC hard ware configuration. GSD file selection in PLC Hard ware configuration is also correct but still Profibus Node's are not getting online for three IND 331 device.
Please find attached Image for detail status of Hard ware configuration in PLC.
What could be the reason..?? Please advice

DP Slave Diagnostic Online.jpg General Online Diagnostic IND 331 Profibus Node.jpg GSD File Name IND 331 offline.jpg Online Status Profibus Node IND 331 Online.jpg
 

Similar Topics

B
DASSIDirect and PLC S7-400H 9wonderware)
Hello everyone, I am lookimg for some help to figure out where come from the problem or what i can do to improve the latency. PLC: S7 416-5h...
Replies
7
Views
2,985
ben_ben
B
H
Slow communication between InTouch (DASSIDirect) and PLC S7-400H
Hello, please help me. I have big problem with communication between DASSIdirect 3 SP1 and S7-417H. I communicate over 5500 tags. There is VERY...
Replies
1
Views
3,831
Thomas_v2
T
C
How to Time Sync? S7-400H CPU (Time Master) With Wincc Runtime V7.5(Time Slaves)
hello s7-400h and wincc are connected to each other via Ethernet. I need help on how to do time synchronization
Replies
0
Views
41
Controller5848
C
N
Issue with Cisco IE 3400H Ethernet Switch
Hi, I'm setting up comms at a station and I'm working with Cisco IE 3400H switches. I have been able to configure them following the Harware...
Replies
7
Views
583
nievesdelimon
N
M
Siemens S7-400H system Modbus TCP/IP connections.
Hello All, For S7-400H system, can we make this redundant PLC (connected to one uplink switch) to communicate simultaneously with 3rd party HMI...
Replies
2
Views
1,439
erikbenson
E
Back
Top Bottom