facing problem with SMC FLEX soft starter

srinaath

Member
Join Date
May 2017
Location
bengaluru
Posts
2
I am facing a problem in which when the emergency stop is pressed, the motor comes to zero speed but going to start state instead of stop state.
i have attached he wiring diagram.
"previous" file consist of my current wiring diagram!
"latest" file corresponds to correction that i would like to do. Is it correct approach?

Please correct me if the following statement is correct.
pin 18 - if low signal is given then stop command is enabled!
pin 17- if high signal is given then start command is enabled!
am i right?

latest.jpg previous.jpg
 

Similar Topics

Hi Friends, I am facing a problem with encoder adjustment in Sew Electric Cylinder CMS71L. encoder using is Sick Hiperface Drive is MOVIDRIVE...
Replies
16
Views
628
Hi everyone, I am facing a problem with my F5 series KEB Frequency drive. I have cobivis5 software and HSP5 service cable for interfacing. i am...
Replies
1
Views
2,065
I'm working in Schneider PLC platform and not aware of RSlogix. In my new project I need to communicate my Quantum PLC with 1756-L55 controller...
Replies
1
Views
1,684
I'm trying to interface plc and scada where scada is monitoring and controlling the parameter using MODBUSA3 protocol but SCADA is not sending 05...
Replies
3
Views
1,681
hi , Friends I am facing problem with wonderware InTouch in which the tags which are used for alarms is showing the date time of 01/01/1970...
Replies
1
Views
2,630
Back
Top Bottom