Austin1985
Member
Does anyone know off hand how to disable the start signal from a PowerFlex 20-HIM-A6? I've been looking through the manual but I'm not too familiar with these HIM's..
Thanks!!
Thanks!!
PowerFlex 700 series Start Command
- Thread starter Austin1985
- Start date
Mark Snodgrass
Member
In the manual(pg 3-50 for series A or pg 3-47 for series B) is parameter 277- Start Mask. Bit 1 is for the HMI which is DPI port 1.
Austin1985
Member
OP
OK, thanks! I didn't realize it is called Mask, so my "ctrl f" method wasn't working while hunting through the manual.
Again, thanks..
Again, thanks..
Similar Topics
We are using Powerflex 700 VFD to drive the starting motor of gas turbine. Reference speed signal to VFD comes from AB control logic PLC. When we...
I've got a Powerflex 700 that doesn't like to get going in the mornings. This motor will run anywhere from 30 seconds to 5 minutes before it just...
Looking for some assistance. I am very familiar with Yaskawa VFDs, but not so much with AB VFDs. I am working on some hardwired AB PowerFlex 700...
Can someone with Drive Executive please save me a printout of the parameters for this drive in this file. I'm in a bind and would greatly...
Hello all, I was forced to replace a Powerflex 700 to a Powerflex 70 due to what is available. The digital input parameters (361-366) have a...