psychosunshine
Member
I've recently uploaded a project from an S7-200 with MicroWin. There are no comments or symbols.
I later found a copy of the program that has the comments and symbols. Although, that program will not go online with my PLC. Because, the program has been slightly modified.
How can I get the symbols and comments from the original project to my new uploaded project?
I am no longer on site. So, any method of doing this, involving the PLC, I can not do until I get back there.
Thanks.
I later found a copy of the program that has the comments and symbols. Although, that program will not go online with my PLC. Because, the program has been slightly modified.
How can I get the symbols and comments from the original project to my new uploaded project?
I am no longer on site. So, any method of doing this, involving the PLC, I can not do until I get back there.
Thanks.