Send text messages via Omron PLC

Hugo Tavares

Member
Join Date
Jul 2017
Location
Porto
Posts
2
Hello,

I'm trying to use the CJ2W-CPU32, westermo MRD 315 to send messages in case of problems to the operators.

Where should I configure the text messages, configure the phone number, etc? I need to configure a complete system.

Thanks for the support,

Regards,
Hugo Tavares
 
http://accautomation.ca/heres-is-a-quick-way-to-send-email-text-messages-from-the-plc/

The above PLC will send text messages (Via Email) out of the PLC directly.

I would use a computer running AdvancedHMI to communicate to the Omron PLC and then send out the messages.
https://sourceforge.net/projects/advancedhmi/
Here is a thread on sending email using the AdvancedHMI package.
http://advancedhmi.com/forum/index.php?topic=796.0

Here are some free email to sms gateways.
https://www.opentextingonline.com/emailtotext.aspx

Hope this helps you out.
Regards,
 
Hello gclshortt,

In this specific case this is a remote, stand alone equipment.
I have a MRD 315 with a sim card, comunicate with PLC and send text messages in case of any problem.

My problem is how I do the ladder instructions in PLC to perform this actions...

Thanks for the support,

Regards,
Hugo Tavares
 

Similar Topics

Folks, I just joined the forum ! Please suggest/advice about possible options for receiving event notifications over text messages on a CDMA...
Replies
4
Views
3,072
can the slc500 5/05 send a email and text over Ethernet ?
Replies
3
Views
153
may i connect gsm modem SIM900A with with ts adaptor ii , my gsm modem have only 3 pins of rs232 tx , rx and ground ! as i connect the serial...
Replies
0
Views
2,094
Looking for a stand-alone cellular radio for service in the USA - 24Vdc powered, - DIN rail mount, - remote mount antenna (to mount outside the...
Replies
5
Views
2,261
I want to type a message on hyper terminal and send it to Micro controller by using Rs-232 serial cable. Can any one tell me how to do this ...
Replies
0
Views
2,035
Back
Top Bottom