Steve_D
Member
Hi guys, I am about to purchase a Hart to modbus converter to interrogate a few flow meters on hart and get the info via modbus. All looks good except the wiring diagram for the HART PART is very simplistic, i.e the converter at the start and a single line across the line of flow meters with a single line down to each meter. This is clearly 2 wires (+ and -) but I assume they are daisy chained, i.e. the 2 wires out of one become the two wires into the next. Am I right or can I bring two wire into a terminal strip and parallel the signal wires off these?
Thanks in advance
Thanks in advance