1.6 to 2.8 VDC actuator feedback problems

Gyrus

Member
Join Date
Feb 2018
Location
Dammam
Posts
1
Hi All..

I have a fuel controller that only accepts 1.6 to 2.8 VDC feedback from the actuator. I need to replace that with a 4-20 mA or a 0-5 VDC feedback actuator.

Any Ideas on how I can accomplish this??

The fuel controller will not accept changes to its configuration.
 

Similar Topics

We normally ground the -24VDC side of a control systems power supply. What are you folks thoughts about grounding the -24VDC side of a class 2...
Replies
1
Views
84
I have a conundrum with this current circuit. I have a Siemens 1215C AC/DC/Relay and an old drive - Ratiotrol (now Boston Gear company I...
Replies
7
Views
1,146
I have begun using 480VAC power supplies in my panels to keep heat from a transformer out of the panel. This works great if the panel is mounted...
Replies
17
Views
4,087
Good Afternoon , It seems like we always have problems with using Type J Thermocouples with our slip rings . Would using a RTD at 10...
Replies
6
Views
1,622
Good morning, could anyone recommend a 24VDC pulse counter which counts up or down to a preset #? Once it reaches this number, send a 24VDC back...
Replies
3
Views
1,629
Back
Top Bottom