Is it possible to connect a Mitsubishi e1032 to an fx 2n plc with an enet adp card over ethernet ?
I have programmed the plc with the ip address etc and can connect with a laptop using GX developer.
There is a controller driver for this adaptor in E designer but it will not communicate.
General consensus is its not possible as the adaptor is not a real ethernet card just a serial to ethernet convertor but if this is the case why is there a driver in E designer for it.
I have programmed the plc with the ip address etc and can connect with a laptop using GX developer.
There is a controller driver for this adaptor in E designer but it will not communicate.
General consensus is its not possible as the adaptor is not a real ethernet card just a serial to ethernet convertor but if this is the case why is there a driver in E designer for it.
