Not Sure why I can't implement this piece of PLC-5 logic in a Micrologix 1100 !!!!!!
In Micrologix 1100, S:42 = RTC Seconds Register.
I want to use S:42/0 to toggle a bit so I can have a pretty accurate 1sec timing Pulse.
Is it not possible to address the Real time clock Seconds register in Micrologix 1100 to bit level?
Also, RSlogix 500 does not like the two one-shots with a single output. Say's each one-shot must have an output attached to it. My Rslogix 500 Version = 7.00.00. Any ideas why? A work around perhaps?
-Thanks
In Micrologix 1100, S:42 = RTC Seconds Register.
I want to use S:42/0 to toggle a bit so I can have a pretty accurate 1sec timing Pulse.
Is it not possible to address the Real time clock Seconds register in Micrologix 1100 to bit level?
Also, RSlogix 500 does not like the two one-shots with a single output. Say's each one-shot must have an output attached to it. My Rslogix 500 Version = 7.00.00. Any ideas why? A work around perhaps?
-Thanks
Last edited: