M340 NOE100 IO Scanning Modbus Comms to AB PowerFlex 753 Drive

scader

Member
Join Date
Oct 2014
Location
USA
Posts
2
Setup:
- Schneider Electric M340 PLC w/ NOE 100 Module installed
- Allen Bradley PowerFlex 753 VFD w/ 20-COMM-M Modbus Adapter installed
- Protocol - Modbus TCP/IP

Objective:
Communicate via IO Scanning to PowerFlex Drive for Logic Status/Command and Reference

My question is has anyone had anyone tried this setup and had any luck? Or does anyone with "higher intelligence" than me have any ideas on how to implement this.

I configured the IO Scanner Line as follows:
IP - IP setup in the 20-COMM-M on the drive
Unit ID - 255
Slave Syntax - Modbus
Health and Repetitive Rate - Default

I used a IO Scanner line each for read and write addresses.
Any help is appreciated.
 

Similar Topics

I have 9 field devices, three METSEPM5110 power meters and six ACE949-2 rs285 interface modules. I want to read this Modbus rtu data through rs485...
Replies
8
Views
270
I'm using M340 (Schneider Electric) as modbus master. It works fine but if there is a disconnection with the slave, it stops working even after...
Replies
2
Views
383
Hello, I am trying to send sms messages using SR2MOD03 with an M340 and can't find anything related to it on the internet, can you please help...
Replies
0
Views
195
Good day, I have an issue between an M340 PLC and a PRA 0100. The problem is as follows: I have a communication link between the PLC and the PRA...
Replies
0
Views
819
Hello, Not able to find Modicon DO modules BMXDDO3202 in EcoStructure Control expert V15 catalogue. But i can find only MBXDDO3202K. Can you...
Replies
2
Views
453
Back
Top Bottom