with high speed counter boards that fit into either port 1 or 2 of the cpu on the omrom cqm1h plcs thers is some configeration to do when setting them up ie reset method etc. i know all the configeration information to put in but the manual says this information should be put into different DM bits. what i need to know is is there a way to get it in and stay there ie use a move instrucion to move values into the locations at the start of the prog or do i need to configure a page in the setup page in syswin.
i am unsure on the way to tackle this so could anyone help or send me in the right direction
thanks to anyone in advance
andy
i am unsure on the way to tackle this so could anyone help or send me in the right direction
thanks to anyone in advance
andy