Timeismoney08
Member
I'm getting used to using AutoCADe, but I seem to have trouble with getting the scales right. I used the IEC standard template for the .dwt, but when I go to a project and create a new project (using that template), the scale is funky.
I can set the ladders I drop in to 160 width and spacing between the rungs to 20, but the rung numbers are out of portion compared to the rung lines..
Also, I can change it in the project settings, but then it makes the wire connections about 20 times to large.
Any tips?
Thanks!
I can set the ladders I drop in to 160 width and spacing between the rungs to 20, but the rung numbers are out of portion compared to the rung lines..
Also, I can change it in the project settings, but then it makes the wire connections about 20 times to large.
Any tips?
Thanks!