Some how I managed to mess up my 5/04 and rs linx. Now when I do auto config. the baud rate come in at 1200 instead of 19200.
I know that I hit the wrong setting when configuring a different project but I just dont know what one(s). Aparently I must have changed some thing in the processor but I cannot go on line at all to change any thing.
I have pulled the processor out and reset it by shorting the ground/vbb together for about 60 seconds, and that doesn't work.
It is supposed to be running on DH+ from my serial port on my tough book with a cp3 cable. I dont have a clue what to do next.
Thanks
I know that I hit the wrong setting when configuring a different project but I just dont know what one(s). Aparently I must have changed some thing in the processor but I cannot go on line at all to change any thing.
I have pulled the processor out and reset it by shorting the ground/vbb together for about 60 seconds, and that doesn't work.
It is supposed to be running on DH+ from my serial port on my tough book with a cp3 cable. I dont have a clue what to do next.
Thanks