I have a small project coming up (20 or so pneumatic valves with feedback) the customer has expressed interest in Asi bus.
After searching the forums I see most questions were asked in 2009 - 2010.
Question is....is this the right way to go? Is it still a current protocol?
We will be using a control logic Plc.
My other questions are (if yes to above)
How Nema 4x is it? If the cable is run free air and the clamps are the "vampire" clamps. It will be used in milk processing so wash down is high pressure with caustic foam.
I have seen from other post's that noise can be an issue....how do you run this with shielded cable? Would I run it in conduit and "splice" in a junction box?
Thanks.
Darren
After searching the forums I see most questions were asked in 2009 - 2010.
Question is....is this the right way to go? Is it still a current protocol?
We will be using a control logic Plc.
My other questions are (if yes to above)
How Nema 4x is it? If the cable is run free air and the clamps are the "vampire" clamps. It will be used in milk processing so wash down is high pressure with caustic foam.
I have seen from other post's that noise can be an issue....how do you run this with shielded cable? Would I run it in conduit and "splice" in a junction box?
Thanks.
Darren