Endress+Hauser Flow Meter
- Thread starter randheerp
- Start date
is it possible to get the flow meter data to the PLC over an ethernet connection?
Looking at the above it seems only the following connections are available
Communication:
HART - 4-20mA
PROFIBUS PA - Profibus network
FOUNDATION Fieldbus - ??
Outputs:
4...20mA
Pulse/Frequency
Status (can I get this over ethernet to a Compactlogix PLC?)
How would I get this information over to a compactlogix PLC using an ethernet connection?
Here is the part info
83F40-8410/0
83F40-AFTAAAAABAAI
Promass 83F40
Looking at the above it seems only the following connections are available
Communication:
HART - 4-20mA
PROFIBUS PA - Profibus network
FOUNDATION Fieldbus - ??
Outputs:
4...20mA
Pulse/Frequency
Status (can I get this over ethernet to a Compactlogix PLC?)
How would I get this information over to a compactlogix PLC using an ethernet connection?
Here is the part info
83F40-8410/0
83F40-AFTAAAAABAAI
Promass 83F40
widelto
Member
Poyserdk:
Yes, new flowmeters from endress+hauser have ethernet/ip connection.
Yes, new flowmeters from endress+hauser have ethernet/ip connection.
Similar Topics
Hi,
The hardware is: Click Plc model # CO-O1DD1-O HMI model # S3ML-R magnetic-inductive flow meter model # FMM100-1001.
I will set the flow meter...
Dear All,
I need a sample PLC program to count the output pulse of a mass flow meter so that a specific amount of mass (for example 100gm)can be...
Has anyone installed Hp laserjet pro 4203 to OMNI 3000 or 6000 via ethernet..Is there a specific Config? I have a problem..Please advise
I can't seem to figure out how to add descriptors to I/O points on an RMC using PCCU.
Say, for example, I want to use "Valve_1" as a descriptor...
Greetings ...
someone sent me a request for some student handsouts that I developed ... turns out that I had this hosted on my business website...