Slc 5/03 With Panel View

prasadgaru

Member
Join Date
Jun 2008
Location
*******
Posts
11
DEAR ALL,

I AM USING SLC REDUDENCY PROCESSOR WITH 1747 - L531, 1747 - BSN, WITH REMOTE I/O'S. I AM USING PANEL VIEW 300 MICRO I WANT TO COMMUNICATE BOTH PROCESSOR WITH PANEL VIEW 300 MICRO. THROUGH RS. 232 PORT. KINLDY HELP ME. PLEASE SEND IF YOU HAVE MANUAL TO MAKE A CABLE.

REGARDS

PRASAD

MY EMAIL: [email protected]
 
slc 5./03 with panel view 300 micro

Mickey said:
See PDF below for cables guide

dear mickey,

you have send manual for only one connection could you send me the connection for both the processor if one fails another should take over.

bye

regards

prasad
 
send me the connection for both the processor if one fails another should take over.

I am not familiar with redundant systems, so I'm not sure how you would do that. Hopefully someone who is will jump in and help out.
 

Similar Topics

Hi. I am upgrading from an old dead panel view to a newer panel view plus 7. My question is : 1.will the new hmi communicate via a 1761-net-eni...
Replies
6
Views
823
Panel view CAT number 2711-K5A2 Getting fault "612 No active mode found on network" Not sure if connected correctly and channel configuration is...
Replies
8
Views
1,995
Can a SLC 504 or 505 have there rtc changed from there ladder or from a panel view connected to it? I have been searching this in the forum and on...
Replies
7
Views
3,598
This is my first posting: I have Problems with Uploading a Panel View 550 connected to an SLC 5/03 Allen Bradley SLC 5/03 1747-L532 PLC...
Replies
8
Views
13,579
Hi, I want to connect a Panel View 300 through Ethernet to an SLC-5/04.But my PLC support RS-232/DH+ and would appreciate some advice on...
Replies
6
Views
4,003
Back
Top Bottom