LG Ni 1000

Hello everyone,

I am currently using an Allen Bradley 2080-RTD2 Module for the LG Ni 1000 Sensor. Unfortunately I can't get any reading from the PLC.

The module is only capable of supporting the following sensors

100 Ω Platinum 385,
200 Ω Platinum 385,
500 Ω Platinum 385,
1000 Platinum 385,
100 Ω Platinum 392,
200 Ω Platinum 392,
500 Ω Platinum 392,
1000 Ω Platinum 392,
10 Ω Copper 427,
120 Ω Nickel 672,
604 Ω Nickel-Iron 518

I was assuming that I can still get a reading regardless of the type of the sensor.

My question is do you think that the RTD module is not capable of measuring the LG Ni Type Sensor?

Thank You.

https://literature.rockwellautomation.com/idc/groups/literature/documents/um/2080-um004_-en-e.pdf

Based on the information of the RTD, you should get some kind of reading.
https://w5.siemens.com/web/cz/cz/corporate/portal/home/produkty_a_sluzby/IBT/mereni_a_regulace/regulatory/ekvitermni/Documents/Albatros2/dokumenty/Ni1000.pdf
Platinum 1000
http://www.thermometricscorp.com/PDFs/Platinum-1000-Ohm-385.pdf

Have you checked the wiring and settings of the plug in module from the manual above?
Regards,