Magelis HMI not working as intended

16000lc

Member
1
Join Date
Nov 2022
Location
Portugal
Posts
1
Good morning friends.
. We are having a problem with one of our machines that have two HMI consoles connected to the same network. They have alarms that are activated by certain bits. What is happening is that one of the consoles has active alarms without the bits being active. We are sure that they are communicating with each other because there are fields in which if we make changes both consoles update.
Does anyone have an idea?
thanks
https://freeimage.host/i/H394Ues
https://freeimage.host/i/H394gmG
Magelis XBT F024610
 
Last edited:

Similar Topics

EICS
Modicon M238 PLC & Magelis HMI - What software Needed ?
I am looking at a bakery oven that has been dismantled and in storage for unknown time, it was manufactured in 2012 so not that old. my gig is to...
Replies
8
Views
3,594
EICS
EICS
T
Magelis XBTGT1335 (HMI)
The above HMI does not power up and is located on a Caribbean island. This started after a 24 hour power outage. It has power now but the screen...
Replies
2
Views
1,207
ThomasGruetter
T
R
Schneider M241 and HMI magelis communication problem
I have an M241 connected in Ethernet to a HMIS5T panel and I can't get them to communicate I'm using Machine Expert 1.2 On the controller the...
Replies
0
Views
1,792
rgua
R
T
Software & cables for uploads from Twido PLC & Magelis HMI
We're an industrial machinery merchant and it behooves us to try to get uploads from all the various control systems that pass through our doors...
Replies
5
Views
4,774
technolog
T
T
Schneider Electric HMIS5T Magelis HMI upload possible?
I've seen a few old threads on here that say there is no way to upload from one of these HMIs unless the developer took the step of downloading...
Replies
2
Views
2,642
Saffa
S
Back
Top Bottom