Andrew EPS
Lifetime Supporting Member
Hi, I want to connect a Schneider Magelis HMIS5T to a Danfoss FC102 via Modbus to display some values and just having some issues with the addressing. The Vijeo software allows for the Modbus driver to use addressing as 40001 + the offset. So if I am looking at DC Bus voltage parameter 16-29 I would assume address would be 40001 + 1629 = 41630. I've also seen suggestions it should be 16.29*1000 + 40001 = 56291 but this takes it outside the range 40001-49999. I'm not too good on this sort of thing but any assistance would be appreciated.
Last edited: