chandrapaul
Member
Hi,
I am testing compact pid control. i used %MD0 (Real) as a set value. but when i modify the value then it does not change properly. check the picture. i put 50 but its showing 47 point something. then again inserting some value but it does not change. what is the problem? may be i am doing something wrong. kindly help i am new in TIA portal.
Thanks
I am testing compact pid control. i used %MD0 (Real) as a set value. but when i modify the value then it does not change properly. check the picture. i put 50 but its showing 47 point something. then again inserting some value but it does not change. what is the problem? may be i am doing something wrong. kindly help i am new in TIA portal.
Thanks