Siemens S7-200 conversion

bill4261 · Nov 6, 2017

Can Anyone convert an old Siemens MicroWin program to version 3.2 or 4.0? I don't have the older software. I believe its 2.0.

Thanks,

gclshortt · Nov 6, 2017

https://support.industry.siemens.com/tf/WW/en/posts/microwin-file-simatic-manager/85561?page=0&pageSize=10

The above thread may help you out.
Regards,

sigmadelta · Nov 6, 2017

I managed to get V2.1 installed..

bill4261 · Nov 6, 2017

Can you convert this program for me?

sigmadelta · Nov 7, 2017

This is the unmodified conversion, it needs clean-up to compile properly in V4.0.

sigmadelta · Nov 7, 2017

Turns out it was just names of the SBRs and INTs that needed changing (ex: SBR_0 to SBR0, INT_0 to INT0).

See attached... not sure if your CPU type in the project is correct, since I didn't see it in V2.0. Just match it to yours. You should be able to upload in V4.0, you just won't have comments.

bill4261 · Nov 7, 2017

Thanks.

I also found out that Version 2.1 is included on the V3.2 and V4.0 CD's. Here's the steps to convert.

1. You need Step7 Microwin 2.1 to open the file.
2. Deselect Symbolic addressing.
3. Switch to STL view.
4. Save the program.

Thanks again gclshortt and sigmadelta

Siemens S7-200 conversion

bill4261

Member

gclshortt

Member

sigmadelta

Member

bill4261

Member

sigmadelta

Member

sigmadelta

Member

bill4261

Member

Similar Topics