Hi All, I have an issue with a Red Lion Data Station (Crimson 3.0 V707). The Data Station is set up as a Modbus Master TCP/IP and is connected to a Burner Management System and a CompactLogix (RSLogix 5000 V20). The system has been reading the Modbus registers in the Burner System and relaying them to the CompactLogix for about 5 days. Today the Burner Technician disconnected his programming laptop from the Burner System and reconnected the proprietary HMI screen. This is when the Data Station could no longer read the Modbus registers in the Burner system. The Data Station "DeviceOnLine()" shows the connection to the Burner System as healthy, and the only time the Modbus registers are updated in the Data Station is when the "Watch Table" is active and then it is only the registers in the active watch table. I have cycled the power on the Data Station with no effect, but cannot cycle the power at the Burner end.
Has anybody had a similar situation or any thoughts on what the cause may be?
Thanks
Woolie
Has anybody had a similar situation or any thoughts on what the cause may be?
Thanks
Woolie