AJGS
Member
Hi,
I am trying to get RSlinx Version 2.56 to see a 1756-DHRIO/E card in a controlLogic Chassis.
The Chassis is 17 slot with a L71 in Slot 0 and the DH+ card in Slot 1.
RSLinx sees the card and shows it as a Yellow ? mark with no X. it labels it as 1756-DHRIO/E and as Unrecognized Device. I have downloaded the latest EDS which is 7.001, but the module I have is a 7.003
Reading the manual it says to configure the card in RSLinx by Right Clicking and go to Module Configuration. However my RSLinx does not show that option.
Is it a case of having to upgrade RSLinx? This project is using the Rockwell PLC5 to ControlLogix chassis conversion with 2 X 17 slot racks connected via EN2T cards. I am trying to setup a opc link from the L71 to the original RSView 32 V7.5 Application.
Any help appreciated.
Andrew
I am trying to get RSlinx Version 2.56 to see a 1756-DHRIO/E card in a controlLogic Chassis.
The Chassis is 17 slot with a L71 in Slot 0 and the DH+ card in Slot 1.
RSLinx sees the card and shows it as a Yellow ? mark with no X. it labels it as 1756-DHRIO/E and as Unrecognized Device. I have downloaded the latest EDS which is 7.001, but the module I have is a 7.003
Reading the manual it says to configure the card in RSLinx by Right Clicking and go to Module Configuration. However my RSLinx does not show that option.
Is it a case of having to upgrade RSLinx? This project is using the Rockwell PLC5 to ControlLogix chassis conversion with 2 X 17 slot racks connected via EN2T cards. I am trying to setup a opc link from the L71 to the original RSView 32 V7.5 Application.
Any help appreciated.
Andrew