I'm looking for some idea of what the standard is for Hydraulic Servo Motion with Allen-Bradley.
What is the most common setup to use? I have 4 Hydraulic Axis that are used for positioning.
I looked a few years ago but we never went forward with Allen-Bradley, we did manage to create a Siemens version, we are pretty much standardized on Beckhoff, and our Beckhoff solution has at least 7 years of experience and knowledge built on it but the customer insists on Allen Bradley due to what they have as far as spares and available support.
I briefly talked to Delta Motion because there didn't seem to be a cut and dried AB solution.
https://deltamotion.com/products/motion/rmc150/#
When I was a AB/Siemens programmer mainly, I never did motion stuff so I'm very weak knowledge wise on AB and motion.
thanks in advance for any advice.
What is the most common setup to use? I have 4 Hydraulic Axis that are used for positioning.
I looked a few years ago but we never went forward with Allen-Bradley, we did manage to create a Siemens version, we are pretty much standardized on Beckhoff, and our Beckhoff solution has at least 7 years of experience and knowledge built on it but the customer insists on Allen Bradley due to what they have as far as spares and available support.
I briefly talked to Delta Motion because there didn't seem to be a cut and dried AB solution.
https://deltamotion.com/products/motion/rmc150/#
When I was a AB/Siemens programmer mainly, I never did motion stuff so I'm very weak knowledge wise on AB and motion.
thanks in advance for any advice.