OMRON C200HW-PRM21 communication cable

kalabdel

Member
K
Join Date
Feb 2015
Location
Ontario
Posts
1,108
Hello guys,

I need to change the configuration on an C200HW-PRM21
PROFIBUS-DP Master Unit and looking communication cable. Any one knows where to get one? Is there another way to configure the module or is this the only way?


Thanks
 

Similar Topics

S
omron c200hw-drm21-v1 problem
need help, Hi i'm new. My deviceNet master drm21-v1 show an error, E2, then the whole system will power off. The power supply come back...
Replies
1
Views
2,760
Jay Anthony
Jay Anthony
BobB
SMS messaging from an Omron CJ2M-CPU31
Has anyone done SMS messaging from an Omron CJ2J-CPU31 PLC? If so could you help please. Omron here in Oz have not had any experience doing this...
Replies
2
Views
56
lostcontrol
L
I
omron cj2m with scada comunication
I have an old plc in the system I have, moxa nport was used to communicate with scada, I want to replace the plc with cj2m cpu33 and eliminate...
Replies
1
Views
50
IO_Rack
IO_Rack
J
Omron CJ2m cpu33 - reading codes
Hi all, i have 8 CJ2m plc units that show different numbers on the plc display and i am stuck on reading the info. my unit has an ip address of...
Replies
3
Views
88
chelton
C
K
Siemens S7-1200 with Omron M1 - Modbus RTU
Hi all, Currently having trouble getting a speed reference to write over modbus to an Omron M1... I can successfully write a run command and...
Replies
6
Views
251
KalvMavin
K
Back
Top Bottom