Hello all, new on here, and relatively new to plc programming.
I am trying to write a program which counts as it receives a cycle end input, and after a set number of cycles turns on an output for a set time, then the out put turns off and the count resets to zero and does this cycle again.
This is what i have,
Input I0 - Cycle end
Counter C0
Output Q0
Pretty basic I know, but i cannot turn off this output after a set time, or reset the counter, i spent a good while trying to figure it out
Would be grateful for any advice help
Thanks
Mick
I am trying to write a program which counts as it receives a cycle end input, and after a set number of cycles turns on an output for a set time, then the out put turns off and the count resets to zero and does this cycle again.
This is what i have,
Input I0 - Cycle end
Counter C0
Output Q0
Pretty basic I know, but i cannot turn off this output after a set time, or reset the counter, i spent a good while trying to figure it out
Would be grateful for any advice help
Thanks
Mick