I can't not upload program from NT20M (again)

smile · Sep 10, 2004

I have touch screen model NT20M (Omron).
and use software NT version 2.33.
and use cable for interface(refer lower picture) between PC and NT20M at port no.1. (refer picture uppper).

What happen ? The software can't upload program from NT20M.

Please Hint to me.

smile · Sep 10, 2004

next picture

pic

ArikBY · Sep 10, 2004

Hello

In the NT touch screens you need to be in Transfer Mode to connect to your PC.
Did you switched the panel to this mode?
To switch to this mode you need to hold on two corners of the panel until the screen will change (in few seconds).

I hope I helped.

kennyb · Sep 10, 2004

As well as being in transmit mode you will possibly have to change the port settings on the PC or laptop. I think its 9600 baud rate, 7 data bits, even parity, 2 stop bits. At least that worked with an NT31 and I can't remember where I got that info!Best of luck.

ArikBY · Sep 10, 2004

As your request in the privet massage here some more orders for transmitte mode.
Get the book it will save you time.

smile · Sep 10, 2004

ArikBY said:
Hello

In the NT touch screens you need to be in Transfer Mode to connect to your PC.
Did you switched the panel to this mode?
To switch to this mode you need to hold on two corners of the panel until the screen will change (in few seconds).

I hope I helped.

Mr.ArikBY
I don't understand, please hint me again.
Smile

ArikBY · Sep 10, 2004

As you see in the above pic press on 2 from 4 corners of the screen the panel will swicth to setup mode, then select transfer mode.

smile · Sep 10, 2004

Mr.ArikBY

I has NT20M my screen not have switch.

ArikBY · Sep 10, 2004

The touch screen is builded from matrix of switches see the 1st pic
Press on the two point I marked until the screen will change.

smile · Sep 10, 2004

not happen

now i press few second but not happen.
Help me again Sir.

smile · Sep 10, 2004

and not happen

i press same you hint but not happen.

ArikBY · Sep 10, 2004

It not going so easy, do it with two hends and touch only the corners

smile · Sep 10, 2004

behind of NT20M has dip sw.

behind of NT20M has dip sw. How set the dip sw. ?

ArikBY · Sep 10, 2004

That what Omron offerin about NT20M
http://oeiwcsnts1.omron.com/pdfcatal.nsf/PDFLookupByUniqueID/37D5B491B22A92648525683F00627EE0/$File/M12V004E12397.pdf?OpenElement

I dont have the book in front of me.The last time I used NT20M was in 1995.So I do not remember all the dip SW on the back.

ArikBY · Sep 10, 2004

That the position of the NT20S.
It shuold be a same in nt20M.

I can't not upload program from NT20M (again)

smile

Member

smile

Member

ArikBY

Member

kennyb

Member

ArikBY

Member

smile

Member

ArikBY

Member

smile

Member

ArikBY

Member

smile

Member

smile

Member

ArikBY

Member

smile

Member

ArikBY

Member

ArikBY

Member

Similar Topics