timbo_uk
Member
Hi,
Just starting to code a new project. Not used FIFO's before. I have read the instruction help file in RSLogix, and think I have got it .
CAn you look at the attached ladder and see if I am on the right lines.
The idea is when a tank is empty the tank number is loaded into the buffer, then ignored until it has been filled.
In a later ladder, before the tank is actually filled I will check the status of the input again before filling. After filling I will reset the latch.
Hopefully I got this right!
Fingers crossed
Just starting to code a new project. Not used FIFO's before. I have read the instruction help file in RSLogix, and think I have got it .
CAn you look at the attached ladder and see if I am on the right lines.
The idea is when a tank is empty the tank number is loaded into the buffer, then ignored until it has been filled.
In a later ladder, before the tank is actually filled I will check the status of the input again before filling. After filling I will reset the latch.
Hopefully I got this right!
Fingers crossed